QY330 type Steering wheel horn contact rotary wearable testing machine
A, steering wheel clamping
1, the first right-hand crank handle backwards, so that the pressure wheel to rise (with hammer)
2, after the back of the hand crank wheel, wheel to move to the rear end of the pressing to install the steering wheel.
3, install the steering wheel, and tighten. Note: You must set a different steering wheel installation mandrel, according to uniform height, arranged in different mounts (see below)
4, hand crank rear wheel, so that the pressure to move to the front wheel on the steering wheel. Note: can not touch the top of the steering wheel at the outer edge of the shoulder surface pressure wheel ensure more than 5mm gap.
5, turn on the right handle, the pressing wheel steady pressure on the steering wheel.
Note: Check with the hammer on the rear side of the chain must be in a relaxed state, otherwise it will offset the pressure of heavy ..... weight.
6, setting the time and the number of test requirements, start running.
7, the left has broken hammer cutout, power supply 220V, non-professionals do not open the protective cover of the switch.
8, counter and timer settings
Power, the first counter and the timer is cleared, then the preset test time and frequency automatically after boot record. If the half-way down, and then the data will be retained after power, will continue recording after power on. To re-set, as long as can be cleared at any time.
